At K 2022 in Düsseldorf, Germany, Lindner will be presenting ground-breaking all-in-one solutions for the efficient plastics recycling of tomorrow in Hall 9, at Booth B17 & B19. Along with a wide range of product innovations, a special highlight is a new system solution to directly process post-consumer rigid plastics in an injection moulding process.
The circular economy and the growing importance of plastics recycling under the umbrella of climate protection are key topics at October’s K in Düsseldorf. Undoubtedly, there has been an upswing in plastics recycling for several years. The challenges facing the industry, however, continue to be multifaceted and complex: demand on recyclate quality is increasing as is the call for higher throughputs with minimal energy consumption and maintenance. The driving force behind this is clear: Plastic needs to be retained in the cycle for as long as possible and the aim is also to use recycled plastic material increasingly in the food sector. The key to recycling success lies in the perfect coordination of the upstream processes of shredding, washing and sorting. As one of a few recycling specialists, Lindner offers all-in-one solutions to effectively optimise these steps while processing rigid plastics, film and PET.
Optimal performance from the outset
Shredding waste plastic is right at the start of the plastics recycling process – an area in which Lindner can apply its decades of experience in the processing of domestic, commercial and industrial waste to obtain standard throughputs of 40 t/h and more. At the K 2022, Lindner will be presenting the upgraded Jupiter BW series for the first time. This product innovation is focused on optimising the handling of plastic films for the downstream NIR sorting process. In addition to a constant volume flow and homogeneous larger particles, this also includes optimising the particle size for NIR sorting. ‘With a particle size of DIN A4 to A3, we have been able to improve the performance of the NIR systems with our customer,’ says Stefan ScheiflingerEhrenwerth, Head of Product Management at Lindner. ‘Every shredding process generates a certain proportion of fines along with the targeted ideal particle size. With the new, resource-efficient Jupiter BW setup we have managed to reduce the proportion of fines generated by 50%, which manufacturers of NIR sorting equipment have confirmed.’ As a result, the newly developed cutting system of the Jupiter BW series is able to significantly increase the added value along the chain.
Focus on quality and efficiency
Besides shredding and sorting, the washing process is also a key quality criterion for producing high-quality regranulate. Not an easy challenge if you consider that plastics are increasingly extracted from waste streams, which is how heavily contaminated input materials are gradually finding their way into plastics recycling. ‘We are only too familiar with the problem. But we also have the right solutions,’ says Harald Hoffmann, Managing Director of Lindner Washtech, Lindner’s subsidiary specialising in plastics recycling. ‘Our patented Rafter pre-wash has been tailored to the new requirements. By using a larger rotor, we can lengthen the dwell times, which obviously has a positive effect on the depth of cleaning. We have also been able to sustainably improve the throughput rate, 3 t/h for films and 5 t/h for rigid plastics – and we will be showcasing this product innovation at the K trade fair for the first time,’ adds Harald Hoffmann. Lindner will also be highlighting another product innovation, this time in thermal drying: ‘At the K we will also be introducing EcoDry, our new thermal dryer. Clever use of heat exchangers and a sustainable insulation of the material-conveying components means this dryer achieves energy savings of up to 30 %. And the high degree of drying also ensures the flakes are better prepared for subsequent processes.’